Web Analytics Made Easy -
StatCounter
TESTED AND TRUSTED: See How To Get 100% Electricity With Copper Wire And Plug | MadNaija
News Tech

TESTED AND TRUSTED: See How To Get 100% Electricity With Copper Wire And Plug

TESTED AND TRUSTED: See How To Get 100% Electricity With Copper Wire And Plug

Do you want to make your electricity? Then you’re at the right place cause in this article I will be showing you a step-by-step guide to making your generator.

A generator is simply a device that converts mechanical energy (itself derived from coal, oil, natural gas, wind, water, nuclear reactions, or other sources) into electrical energy. Here, we describe how to use readily available materials to make a simple generator. Although it will only be powerful enough to light a small torch bulb, it works on the same basic principles as the power station generators that supply domestic electricity.

READ FULL DETAILS HERE

Everyday what we hear Nigerians shouting is all about the problems of electricity in their house and mostly the community at large. However, a lot of Nigerians had resulted in buying mini generators for their daily consumptions.

In this article, I will teach you how you can use copper wire and plug to lighten your bulb every day.

Why this is more effective than a generator

(1) It’s not costly

(2) It’s easy to set up

(3) It doesn’t cause any hazard

(4) It can run for over 1 year nonstop.

(5) It doesn’t cause pollution.

Please I will implore you not to be stingy, share this useful article with everyone around you and let us all enjoy this opportunity. With this, you are safe from darkness forever.

Continue reading if you want to know the details!

ALSO SEE:  A Mechanic Guy Couldn't Believe a Lady he Sent Transport Fare Would Honour his Invitation (Photos)

Instruments

(1) two plugs of the same size

(2) a copper wire

(2) a glue

(4) a flat wooden plyboard

(5) a Lamp holder

(6) soldering iron

(7) magnet

Procedures to be free from the darkness in your house

READ FULL DETAILS HERE

Stet by step procedures

(1) Get your plugs and place the plywood on the ground or flat surface, and then use your glue to hold the two plugs on the board.

(2) Use the copper wire to make a ring shape by rapping it over a biro, just like I have done in the picture below.

(3) Once you’re done with the coiling then, sold it to the plug.

(4) Now, all you have to do is to get your lamp holder and connect the other terminal of the plug to it just like I did in the picture below.

(5) For the best result, I will encourage you to use a big magnet cause the bigger it is, the better for you. After you have your magnet, then place the magnet in between the two plugs making it touch the two sides of the plugs, as shown below.

Note this can enable you to charge your phone, power bulb, use other appliances with 220V or below. To put it off, just remove the magnet and the light will go off.

READ FULL DETAILS HERE

However, if it stops working just buy another plug and reconnect. Thanks for reading.

ALSO SEE:  Osagie Ize-Iyamu, Appears In Court Today Over N700m Alleged Fraud - APC Candidate In Edo

If you have any questions please do ask in the comment section. Don’t forget to share this and follow us for more updates on technology.

Source: Pinterest

About the author

Madnaija

Leave a Comment